KB Bell Housing Removal

GRD-214 Bell Housing Removal

There are two line up pins between the motor block and the bell housing where they meet.One is just below the starter and the other on the passenger side.

You only have to drive them out of either the motor block or the bell housing to do your separation. the passenger side pin hit the flywheel before it cleared the engine block.  I used a hacksaw to cut about 1/8 inch off the pin to free the bell housing.

The bell housing will then lift straight up. The reason you have to go up is that there is a flange that forms part of the bell housing yet slides down in front of the fly wheel from the top.

Watch when you put these alignment pins back in, the cast ears, so close to the edge of the flanges, are easily broken.


About jimhadfield

Retired and enjoying it.
This entry was posted in How Do I Do That?. Bookmark the permalink.

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s